http://www.xtremesystems.org/f…read.php?s=&threadid=7448
ZitatI did the mod for vdd voltage by soldering a pot that is 1kohm and 0.75w.
Board then never booted up .
Board now seems dead as it starts but gives no display and no post beeps.
The LED says "7L".
Removed the mod and it is still the same...
Any ideas?
ZitatAlles anzeigenI know what I did wrong now! Soldered the right chip but the wrong pins on the opposite side of what I should have soldered
I assumed pin was pin 1 on both sides of the Chip!!!
So I soldered pin 5 and pin 8.
What does this mean?
Can I just replace the IR3037 chip , or would the board be damaged as a whole.
ZitatHOLD THE PHONE.
I had it on the right way but forgot to plug the monitor in!!!
3 hours went by testing and checking .
Now we are in business.
Stuck it on 220 fsb and it is fine.
I´d never though it could be pushed this far at all.
rofl, isch kann nischt mehr :wand